[XBee] XBee Factory

今天就靠這篇救回我一顆爛掉的XBee, 趕快筆記一下以免以後又要搞很久

1. Take the module out of the interface board.
2. Connect the interface board to the computer.
3. Open X-CTU make sure Baud Rate is set to 9600
4. Go to "Modem Configuration"
5. Put a check in the "Always update firmware" box
6. Select proper modem from drop down menu,
7. Select proper function set and firmware version from drop down menus.
8. Click on the "Write" button. After a few seconds of trying to read the modem, you will get an Info box that says Action Needed. At this point, CAREFULLY insert the module into the interface board.
9. You may get the info box again a short while after, just use the reset button on the interface board.

reference: Xbee Factory -Hardware reset without serial communication